Forums › Forums › K3 Dashcam › INNOVV K3 WIFI light not lighted after changing the battery. › Reply To: INNOVV K3 WIFI light not lighted after changing the battery.

  • Hans

    Administrator
    2024-09-15 at 00:23

    Hi Adrian,
    you can put the firmware on your new SD card without any problems.
    Make sure you put the firmware file in the root of your SD card.

    At the power converter, is the blue LED still on? If not, there is a problem with your power supply. Perhaps a connector is no longer properly connected.

    It is possible that the K3 was turned on by the parking mode while changing your battery. You will undoubtedly have moved the motor while changing the battery. If the K3 then turned on and you disconnected the power supply, the SD card may have become corrupt. Can you format it in your computer and then see if the K3 starts up properly?

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .