Forums › Forums › H5 Helmet Cam › Mounting the INNOVV H5 › Reply To: Mounting the INNOVV H5

  • Hans

    Administrator
    2024-12-09 at 22:04

    Hi Herman,
    A mounting system could be a solution. I am just curious about the forces that would be exerted on such a system because the H5 sticks out more and catches wind than an intercom system. Perhaps Innovv’s R&D would like to think about this.

    With other camera systems I only see adhesive mounting systems.
    My experience with adhesive plates is that you have to degrease the helmet very well. Preheat the place on the helmet where you are going to stick it with a hair dryer. Also heat the adhesive strip with a hair dryer. Then stick the adhesive strip and press firmly for a while. Do not immediately put a load on the adhesive strip.

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .