Reply To: Auto Shutdown Failure

[Hans]

Hi Andrey,
The VCC and ACC should not be swapped.
ACC, yellow wire, should be a contact switched power supply.
VCC, red wire, should be a constant + power.
Black wire should be a constant – power.

I have tested the following myself:
Set the WiFi timer to 1 minute.
Turn off K6 by disconnecting the yellow wire, K6 goes off after 20 seconds.
Yellow wire connected K6 goes on and K6 wifi becomes active.
After about a minute the green LED goes off and K6 wifi switches off.
After 2 minutes yellow wire disconnected and K6 switches off after 20 seconds.
If I set the wifi timer to 3 minutes and disconnect the yellow wire within 3 minutes that the K6 wifi is still active, the K6 will still switch off after 20 seconds.
If the WiFi timer is set to ON, the K6 still switches off 20 seconds after disconnecting the yellow wire.

So I cannot simulate your problem.
I am using firmware IK6.20231107.V1.0.01

What if you do a hard reset and then re-flash the firmware?
Perform a hard reset by:
Switch on the K6.
Hold the power button for a long time (about 30 seconds).
The red LED flashes 2x and then goes out again.
Restart the K6, K6 has been reset to factory settings.