Forums › Forums › K6 Dashcam › Consistent SD Corruption › Reply To: Consistent SD Corruption

  • Hans

    Administrator
    2025-06-24 at 02:13

    Hi Luke,
    I think the trickle charger has activated the Thunderbox somehow.
    Why not also connect the – directly to the battery?
    The K6 requires minimum current when it is switched off, so you don’t have to worry about draining the battery.
    If you have connected the – to the battery and you hold the yellow wire against the + of the battery and the K6 starts up well, works well and if you disconnect the yellow wire from the + of the battery and the K6 switches off well, then you know that the K6 is working well. You should then look for the problem with the Thunderbox.
    In general, the experiences with Thunderboxes, exCan here on this forum are not positive.
    As for the firmware update, you can (almost) not break anything. Use an 8 to 32Gb SD card for the update. And if it doesn’t work, you can always perform the firmware update again.

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .