It’s practically immediately after switching it off that it can’t be turned on again. Unfortunately, I couldn’t test if this happens with a different power supply too. It’s a good idea, obviously. I’m always a bit hesitant when it comes to firmware flashing, especially given that there are power problems. I may try this too.

Hi all,

I’m running the K6 on my bicycle. The camera turns on as expected with the described 3-sec button push after I have connected it to the battery. However, after turning it off again, the camera cannot be turned on again. I need to un- and re-plug the battery in order to start it again. Is this expected?