Hi Hans,

Attached is the pic of the yellow wire.

As you can see ,Its connected the right way.

What do we do next?

Thx

-A

Hi Hans,

I was able to debug the issue.

The unit is NOT shutting off AT ALL after the bike is turned off.

The video keeps recording and both cameras are getting hotter.

Also, The front camera LED is still slightly green.

As you recall the connection is directly to the Battery.

P.S I’ve also upgraded the firmware

Any suggestions?

Thx

-A

Hi Hanse

Hi Arnon,
Have you connected the power supply correctly? Red and black wires to continuous power, preferably connected directly to the battery. And the yellow wire to a switched power supply?

AB> The wires are directly connected to the bat with the supplied fuse

Does this yellow wire lose voltage when the ignition is turned off?
Does the…

Read more

Hi Hans,

I was able to isolate the problem.

When I turn off the bike, the red light does NOT stop blinking after 30 sec.

Then (after 2-3 min) the main unit start vibrating and short bips are constantly occurring until it drains the whole battery.

Any ideas?

Thx

-A

Hi Hans

Thank you for the response. below are my answers:

Did you format the SD card with the Innov app?

Answer> Yes the SD is format and working properly.
Can you use a multimeter to measure whether the yellow wire actually becomes de-energized? Or can you physically disconnect it? Then see what happens.

Answer>I’ll have to do that and I’ll let…

Read more

Hello,

I have an issue with a new installation of RC6 on my motorcycle.

After I turn the motorcycle off the front camera is blinking red. This is strange since it should NOT get any power at all at this point.

After that, if I dont disconnect (from the battery) the red cable, the controller starts to buzz and drain the whole battery out.

Is there…

Read more