Besides resetting the EZCan accessory I also disabled “Parking mode” on the app. Just because the camera wasn’t working anyway. Maybe the enabled parking mode was the root of the problem?
The camera works when powered directly. The camera is powered via HEx EZcan, so I connected my laptop to read it out. That seemed OK too, the voltage on the bus indicated 12.5+ V.
However the LED on the powersupply of the camera remained solid blue. No idea why, but after removing and adding back the settings for the camera accessory power in EZcan the LED started blinking blue.
And everything works again! Thanks for your help! Much appreciated! Groet, Michael
Report
There was a problem reporting this post.
Block Member?
Please confirm you want to block this member.
You will no longer be able to:
See blocked member's posts
Mention this member in posts
Message this member
Add this member as a connection
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.