Forums › Forums › K7 Dashcam › K7 and Hex EzCan with parking mode enabled › Reply To: K7 and Hex EzCan with parking mode enabled

  • Hans

    Administrator
    2024-09-03 at 23:49

    Hi Diego,
    I have no experience with the Hex EzCan. But for the switched power supply on my K1600GT (2018) I used the round connector under the passenger seat. This is the connector used to connect the topcase. It is the red / yellow wire.
    After the ignition has been switched off, voltage remains at this connection for 60 seconds.
    The K7 is, if properly secured against draining the battery.
    On my BMW I have no problems with draining the battery. I have a K3, K5, ThirdEye and an alarm system connected. I can start the motorcycle without any problems after a few weeks of standing still.

    switched power 01 (1)
    switched power 02 (1)
    switched power 03 (1)

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .