Forums › Forums › K6 Dashcam › K6 Install challenges… › Reply To: K6 Install challenges…

  • Hans

    Administrator
    2024-10-10 at 02:08

    Hi Bob,
    To avoid any problems with the power supply voltage, I would connect the DC converter directly to your battery. This is to rule out the PDM60 as the source of the problem. I have heard problems from Innovv users who used similar installations (also from other brands).
    A 5V power supply must be able to supply at least 2A. Especially if WiFi is used, at least 2A is a requirement.

    As for the 2 minutes WiFi, do you perhaps have the WiFi Active Duration set to 2 minutes? Set it higher.

    You do not need WiFi to update the firmware. Updating the firmware is only possible from the SD card, see https://innovv.com/pages/k6-dashcam-support

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .