It should be, under 6mts old. Came direct from innovv.

System seems to be intermittent. Sometimes it will Sometimes it won’t. Honestly I give up with it, just want to send it back now and have it fixed or replaced.

I did exactly that this evening, it still didn’t work. Also whilst it was setup without the extensions it wouldn’t always turn on, would take a few attempts. I’ve submitted a ticket now because I’m out of ideas.

Just been out and checked what you suggested, all tight. Took them all apart to check for moisture and they’re all dry and have plenty of free movement. I’m thinking it’s either the rear camera itself or the cable leading to it.

Anyone know what outputs are expected at the connections?

Rear camera was working but has now stopped ?

Connections are good and still water tight.

Used the reset option in the menu but it didn’t help.

Any ideas what I can check, continuity of the cables maybe ?

No power leakage. Is all fed from a relay box, if there was a leak auxiliary lights would also turn on.

Update.

Flashed the firmware. No difference, have given up on the parking mode. Cant turn it off so just dropped sensitivity to minimum. Kept recording for no reason and wouldn’t record when it should, could take bike off stand and push it around and it wouldn’t trigger.

No problems since doing that.

It is the K6 at fault. Didn’t happen before and doesn’t happen if I turn off the sentry mode.

It behaves exactly as it should except somehow the sentry mode gets triggered and it won’t turn itself off once it has.

Have a K6, installed it roughly 3 weeks ago. First week it flattened the battery, dropped it to 4volt, nothing recorded to suggest what set it off.

Turned off parking mode and all was good. Turned it back on and it flattened it again. Happened to see the light on at 0100 this morning and turned it off. Tried bike in daylight and it’s flat…

Read more