Forum Replies Created

  • roly

    Member
    2024-10-05 at 05:55 in reply to: Warning lights constant quick flash.

    Thank you, Hans. It’s a BINGO! I had battery voltage INTO a quick disconnect fitting I had in the INNOVV circuit, but only 8.3V OUT of it. Wiggled the connection and I had battery voltage both sides. I found that the wire to metal crimp inside the connection was bad. I replaced the connection and now the Third Eye works like a charm.

  • roly

    Member
    2024-10-05 at 04:08 in reply to: Warning lights constant quick flash.

    I will give that a try and post the result. I have a VOM and will test for V with no load and under load. I’ll use the same ground currently used.

    (Just got back from a 12 mile trip. The system worked perfectly all the way there. When I restarted the bike, the flashing returned for the entire trip home. BTW I have a 220A CCA, 16Ah. Gel Cell Battery. It’s 2 months old. Same problem before and after the new battery which I swapped only because the original was 6 years old, and I make a lot of long trips. I suspect the flash rate is approximately 240-300 flashes per minute each.)

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .