[andyh]

As result:

First cable with DVR has issue. Killed my first battery and DVR was disassembled to find issue.

Second new cable after about 1 year and ~8000 km failed at same place as first cable. Killed my second new GEL battery.

I lost two new batteries and tons of my time…

Also DVR won’t write cyclic video if flash memery is full!

• This reply was modified 4 weeks ago by  andyh.

[andyh]

Just charge my battery and check – The battery is completly dead after one night

[andyh]

The battery has been revived

[andyh]

Second issue:

If the flash memory is full, the recorder does not overwrite new video over the old files and effectively writes nothing. You will fix this in the firmware, (since it is specified that DRV writes cyclically)?

• This reply was modified 4 weeks, 1 day ago by  andyh.

[andyh]

The same situation has arisen as at the very beginning!
After a year of using the new cable, it has failed again, and the DVR won’t turn off.
If I wiggle the cable a bit or bend it, the DVR turns off.
I believe this is either a factory defect or a design flaw. As a result, I’ve lost my second battery. How can this problem be solved?

[andyh]

….

• This reply was modified 4 weeks, 1 day ago by  andyh.

[andyh]

I’ve back asap when my new cable in shpped to me

[andyh]

Here is a photo of the recorder mount.
The cable is not bent and has some free movement. It is also secured with two plastic holders from the K6 original package in the upper part of my bike.

There is no additional load on the cable. I approached the installation process as carefully as possible.

Good news – my GEL battery is reanimatead and operated as normal, i’ve repaired it by small amperage and dirving bike.

Bad news there are no spare K6 Lens camera cable available in my area, so I will purchase one directly from the INNOVV website.

[andyh]

It was dissasembled once by local service when i have issue with cable.

[andyh]

I found water in the front area inside the DVR (green circle). The back area (where the SD card is located) is completely dry. It seems the water got in while the bike was going through an car wash:

[andyh]

Can you add this part as separate spare part to the shop?

[andyh]

Solved + Isopropyl alcohol after

• This reply was modified 2 months, 3 weeks ago by  andyh.
• This reply was modified 2 months, 3 weeks ago by  andyh.

[andyh]

I’ve dissambled front cam. Seems like a little bit problme to clear lens. Any tips / hacks how to clear?

[andyh]

Thanks for the answer. Seems like it’s not a wearing issue. I took a photo of the lens and noticed there’s too much dust under it. It needs to be disassembled and carefully cleaned.

[andyh]

The regular expluatation speed about 170-210 km / h