adamgiles
Forum Replies Created
-
Hi Stephen.
Unfortunately, the only way to download direct from the camera is to remove the rear plate and plug your PC directly into the USB connector beneath the camera. So not much of an improvement…
I agree it’s a bit of a design flaw.
-
I’ve had my K6 for several years and never had issues with it not turning off.
I have a zzr1400, and was able to take a switched live from the accessories circuit. Many people use a feed from the tail-light. It might be wise to ask on a forum dedicated to your model of motorcycle to get advice on which wires to use.
If you use USB power, you will have to stop the k6 recording before switching off bike ignition.
-
Hi Bernhard.
Unfortunately there isn’t a better manual.
I would definitely recommend installing the power converter instead of powering via USB. The power converter will correctly switch on and switch off the K6, which will avoid corruption to the sd card.
If the USB power is lost whilst the camera is still recording, the k6 will not be able to finalise the video file, and may corrupt the recording.
The k6 will always record separate front and rear videos. But can display individually or combined within the app. You will always have access to the individual files though.
-
Hi Kev.
What app are you using watch the video? Is this on your phone or computer?
Can you see video live from the k6 using the Innovv app?
-
Hi Dean, have you connected the red and black wires to a permanent feed, and the yellow to switch live?
Sorry, not on a Z1000 so can’t really help with camera placement…
-
What spec is the sd card? What format are you recording in on front camera?
Also, how are you connecting the sd card to you computer?
-
You could use a Fuzeblock FZ-1. It wires to battery and can give constant or switched power. You can feed 6 different accessories.
I use it for K6 (constant power), Satnav (switched power), usb socket (switched power), and heated gloves (switched power).
-
Hi David
Yes, just connect as per instructions.
Red and Black to battery or other permanent power supply. Yellow to switched power source.
Camera should start recording a few seconds after ignition is switched on, and stop a few seconds after ignition is switched off.
Adam
-
Hello Bert.
How have you wired in your k6? (USB or supplied power converter?)
At start up the k6 should start recording (red light) and enable WiFi (green light). Check the instructions to see what the light sequences signify.
You can change the length of recording loop in the app, but 5 mins is longest. This makes the files easier to play and download.
-
Hi David.
K6 should be capable of recording 2k on front camera, but if you are happy with 1080 then that’s great.
It will also allow more recordings before the sd card is full 👍
-
Did you format the sd card in the camera?
-
That seems about right.
And the picture interference is at the same point every time you play it back?
Just trying to confirm if it’s a playback issue or recording issue…🤔
-
If Innovv aren’t helpful, give me a shout and I can measure the thread sizes for you.
-
You will probably find downloading videos a bit slow over WiFi, and better to remove card and copy files on PC.
Therefore, you only use the WiFi for changing settings on K6.
3 mins is probably long enough to do this.
-
Good news.