[adamgiles]

You could use a Fuzeblock FZ-1. It wires to battery and can give constant or switched power. You can feed 6 different accessories.

I use it for K6 (constant power), Satnav (switched power), usb socket (switched power), and heated gloves (switched power).

[adamgiles]

Hi David

Yes, just connect as per instructions.

Red and Black to battery or other permanent power supply. Yellow to switched power source.

Camera should start recording a few seconds after ignition is switched on, and stop a few seconds after ignition is switched off.

Adam

[adamgiles]

Hello Bert.

How have you wired in your k6? (USB or supplied power converter?)

At start up the k6 should start recording (red light) and enable WiFi (green light). Check the instructions to see what the light sequences signify.

You can change the length of recording loop in the app, but 5 mins is longest. This makes the files easier to play and download.

[adamgiles]

Hi Nicholas.

Yes, Red and Black to battery (or permanent power), yellow to switched live.

[adamgiles]

Hi Dan.

Yes, red and black to battery (or other permanent power), yellow to a switched live.

It will draw a small amount of power when bike is switched off, but this is minimal.

If you don’t use an optimiser when bike is not used for longer periods, you could disconnect the battery.

[adamgiles]

If the converter is working correctly, try removing and checking all connections.

Are you using the extension cable?

Have you turned the camera on and then switched the ignition off and see if camera shuts off correctly? Takes about 25 seconds .

• This reply was modified 6 months, 1 week ago by  adamgiles.

[adamgiles]

Hi Orfeo.

Does the LED continue to flash? Or does it return to solid blue (or red)?

[adamgiles]

“I installed the K6 device using the DC converter, connecting the positive and negative terminals to the battery and the yellow wire to a terminal activated by the ignition key. The device was previously configured, formatted, and tested using a power bank. Everything worked fine.

I installed the K6 on the motorcycle and connected the device through the DC converter as described above. The solid blue LED indicates standby and when the engine is running the flashing blue LED indicates correct connection and activation of the K6. However, the following happens: the K6 button flashes red and does not stabilize in solid red, I cannot connect to the Wi-Fi and after a short while the device turns off! Help me”

• This reply was modified 6 months, 1 week ago by  adamgiles.
• This reply was modified 6 months, 1 week ago by  adamgiles.

[adamgiles]

Red and black wires should be connected to battery or other permanent power point.

Yellow wire should be connected to a switched live feed, so that the K6 can switch on and switch off correctly with ignition.

[adamgiles]

Hi Coran.

You will need to connect your K6 to a permanent live/earth feed. I assume your acc2 feed is switched with the ignition.

Can you connect to the WiFi with your phone at all?

[adamgiles]

Press button for about 3 seconds. Same to switch off.

[adamgiles]

If Innovv aren’t helpful, give me a shout and I can measure the thread sizes for you.

[adamgiles]

You will probably find downloading videos a bit slow over WiFi, and better to remove card and copy files on PC.

Therefore, you only use the WiFi for changing settings on K6.

3 mins is probably long enough to do this.

[adamgiles]

Good news.

[adamgiles]

Hi Dave.

The K6 will work fine without connecting to your phone (switching on and off with ignition), but obviously the app won’t work if not connected.

K6 doesn’t have Bluetooth .